25k. Name: Ian. Ford Model: Focus. Ford Year: 2014. UK/Ireland Location: Angus. Posted August 12, 2020. Disconnect the minus battery lead for about 10 minutes then put back and start the car and let it idle for a bit then take it for a run and let the ecu learn the new values.
11013posts 路 Joined 2008. #2 路 Aug 30, 2010. They are torque to yield bolts They're supposed to be replaced. The new ones are tightened in two stages, Stage 1: Tighten to 40-45 Nm (30-33 lb-ft). Stage 2: Tighten an additional 90-120 degrees.
Maybethat's a slight exaggeration but it's torque spec truly is 199 ft lbs. 2017 Race Red ST1. Radium Dual OCC's w/ petcocks, PCV Plate & Symposer Delete ; Steeda Jacking Rails & Clutch Assist Spring w/ Perch We鈥檙e the premiere Ford Focus ST forum with discussions on the 2013+ Focus ST. Join the community and see the latest
Hank 85 lb-ft for (rear) lower shock bolt. 41 lb-ft for (front/rear) shock top nut. 18 lb-ft for (rear) upper shock bolts bracket to body (stock), or 25 lb-ft (aftermarket bolts with Massive rear strut bar). These torques are all from sections 204-01 and 204-02 of the factory service manual. 2016 Focus RS, FW / RS2 / Forged
A amc49. 20728 posts 路 Joined 2012. #9 路 Feb 17, 2023. It WILL be inch as I guarantee foot pounds will break the sh-t out of that part!!! Like I said before, no torque needed. Just carefully pull all bolts up EVENLY (easy to tilt the TB to not seal) and hit solid by feel and just the smallest bit more. Plastic parts do not let the screws
318posts 路 Joined 2005. #3 路 Feb 1, 2015. According to the Ford SVT timing procedure, the "aluminum" valve cover is torqued in two stages. Stage 1: 2 Nm. Stage 2: 7 Nm. COSVT03. 4832 posts 路 Joined 2004. #4 路 Feb 2, 2015. Almost all ford torque patterns are spiral out from center.
Ni8qM. st25uujfrn.pages.dev/141st25uujfrn.pages.dev/349st25uujfrn.pages.dev/372st25uujfrn.pages.dev/386st25uujfrn.pages.dev/91st25uujfrn.pages.dev/270st25uujfrn.pages.dev/101st25uujfrn.pages.dev/284st25uujfrn.pages.dev/397
2013 ford focus torque specs
